Telit Wireless Solutions LE910 - 4.1.2. GENERAL CONFIGURATION COMMANDS

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 31 of 509
Mod. 0808 2011-07 Rev.2
4.1.2. General Configuration Commands
Select Interface Style - #SELINT
#SELINT - Select Interface Style
SELINT 2
AT#SELINT=[<v>]
Set command sets the AT command interface style depending on parameter <v>.
Parameter:
<v> - AT command interface style
2 - switches the AT command interface style of the product, to the new products
like LE910 V2
AT#SELINT?
Read command reports the current interface style.
AT#SELINT=?
Test command reports the available range of values for parameter <v>.
Note
Issuing AT#SELINT=<v> when the 3GPP TS 27.010 multiplexing protocol
control channel has been enabled (see +CMUX) causes an ERROR result code to
be returned.