Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 99 of 509
Mod. 0808 2011-07 Rev.2
+CIND - Indicator Control
<ind> - roaming indicator range
0 - registered to home network or not registered
1 - registered to other network
“smsfull” - a short message memory storage in the MT has become full (1), or
memory locations are available (0)
<ind> - short message memory storage indicator range
0 - memory locations are available
1 - a short message memory storage in the MT has become full.
“rssi” - received signal (field) strength
<ind> - received signal strength level indicator range
0 - signal strength ≤ (-112) dBm
1..4 - signal strength in (-97) dBm..(-66) dBm (15 dBm steps)
5 - signal strength ≥ (-51) dBm
Next command causes all the indicators to be registered
AT+CIND=1,1,1,1,1,1,1,1,1
Next command causes all the indicators to be de-registered
AT+CIND=0,0,0,0,0,0,0,0,0
Next command to query the current value of all indicators
AT+CIND?
CIND: 4,0,1,0,0,0,0,0,2
Mobile Equipment Event Reporting - +CMER
+CMER - Mobile Equipment Event Reporting
[<mode>
[,<keyp>
[,<disp>
[,<ind>
[,<bfr>]]]]]
Set command enables/disables sending of unsolicited result codes from TA to TE
in the case of indicator state changes (n.b.: sending of URCs in the case of key
pressings or display changes are currently not implemented).
Parameters:
<mode> - controls the processing of unsolicited result codes
0 - buffer +CIEV Unsolicited Result Codes.
1 - discard +CIEV Unsolicited Result Codes when TA-TE link is reserved (e.g.
on-line data mode); otherwise forward them directly to the TE.
2 - buffer +CIEV Unsolicited Result Codes in the TA when TA-TE link is
reserved (e.g. on-line data mode) and flush them to the TE after reservation;
otherwise forward them directly to the TE.
3 - forward +CIEV Unsolicited Result Codes directly to the TE; when TA is in
on-line data mode each +CIEV URC is stored in a buffer; once the ME goes
into command mode (after +++ was entered), all URCs stored in the buffer
To Next Page
Loading...
Need help?
General
