Telit Wireless Solutions LE910 - E-Mail Management at Commands; E-Mail Sender Address - #EADDR; E-Mail SMTP Server - #ESMTP

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 412 of 509
Mod. 0808 2011-07 Rev.2
4.1.6.10. E-mail Management AT Commands
E-mail SMTP Server - #ESMTP
#ESMTP - E-mail SMTP Server
SELINT 2
AT#ESMTP=
[<smtp>]
Set command sets the SMTP server address, used for E-mail sending.
SMTP server can be specified as IP address or as nick name.
Parameter:
<smtp> - SMTP server address, string type. This parameter can be either:
- any valid IP address in the format: xxx.xxx.xxx.xxx
- any host name to be solved with a DNS query in the format: <host
name>
(factory default is the empty string “”)
Note: the max length for <smtp> is the output of Test command.
AT#ESMTP?
Read Command reports the current SMTP server address, in the format:
#ESMTP: <smtp>
AT#ESMTP=?
Test command returns the max length for the parameter <smtp>.
Example
AT#ESMTP="smtp.mydomain.com"
OK
Note
The SMTP server used shall be inside the APN space (the smtp server provided by
the network operator) or it must allow the Relay, otherwise it will refuse to send the
e-mail.
E-mail Sender Address - #EADDR
#EADDR - E-mail Sender Address
SELINT 2
AT#EADDR=
[<e-add>]
Set command sets the sender address string to be used for sending the e-mail.
Parameter:
<e-addr> - sender address, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
AT#EADDR?
Read command reports the current sender address, in the format:
#EADDR: <e-addr>
AT#EADDR=?
Test command returns the maximum allowed length of the string parameter <e-
addr>.
Example
AT#EADDR="me@email.box.com"
OK
AT#EADDR?
#EADDR: "me@email.box.com"
OK