Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 292 of 509
Mod. 0808 2011-07 Rev.2
#CSURVEXT - Extended Network Survey
SELINT 2
AT#CSURVEXT
[=<value>]
Set command enables/disables extended network survey.
Parameter:
<value>
0 - disables extended network survey (factory default)
1 - enables extended network survey; all the network survey execution
commands (
#CSURV, #CSURVC
) display the BAList for every valid
scanned BCCh carrier
2 - enables extended network survey; all the network survey execution
commands (
#CSURV, #CSURVC
) display the BAList for every valid
scanned BCCh carrier and, if GPRS is supported in the cell, they report
some GPRS informations carried by the System Information 13 of the
BCCh
3 - enables more extended network survey
;
all the network survey
execution commands (
#CSURV, #CSURVC
). It displays transmit power
level, receiving level access min, Cell Reselection Offset, Penalty Time,
T3212 Periodic Location Update Timer and Cell Reselection Offset
AT#CSURVEXT?
Read command reports whether extended network survey is currently
enabled or not, in the format:
<value>
AT#CSURVEXT=?
Test command reports the range of values for parameter <value>.
Notes
and
Platform limits
#CSURVEXT configuration has effect on 2G cells only.
4.1.6.3. AT Run Commands
Enable SMS Run AT Service - #SMSATRUN
#SMSATRUN – Enable SMS AT Run service
SELINT 2
AT#SMSATRUN=
<mod>
Set command enables/disables the SMS AT RUN service.
Parameter:
< mod >
0: Service Disabled
1: Service Enabled

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English