Telit Wireless Solutions LE910 - SMS Commnads Operation Mode - #SMSMODE; SMS Format (3 GPP or 3 GPP2 Mode) - #SMSFORMAT

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 409 of 509
Mod. 0808 2011-07 Rev.2
#SMSMOVE – Move Short Message to other memory
SELINT 2
test 3
OK
//list the SMs to discover the memory index
AT#SMSMOVE=1
OK
//move the SM in the first position of ME to SIM
AT#SMSMOVE?
#SMSMOVE: "ME",2,100,"SM",1,50
OK
//now we have 2 SMs in ME and 1 in SIM
SMS Commnads Operation Mode - #SMSMODE
#SMSMODE - SMS Commands Operation Mode
SELINT 2
AT#SMSMODE=
<mode>
Set command enables/disables the check for presence of SMS Service Centre
Address in the FDN phonebook
Parameter:
<mode>
1 - disables the check for presence of SMS SCA in FDN
2 – enables the check for presence of SMS SCA in the FDN phonebook when
FDN are enabled; if the SMS SCA is not present, then a SMS cannot be sent
(default)
AT#SMSMODE?
Read command reports whether the check of SMS SCA in FDN is enabled or not,
in the format:
#SMSMODE: <mode>
(<mode> described above)
AT#SMSMODE=?
Test command reports the supported range of values for parameter <mode>
SMS format (3GPP or 3GPP2 mode) - #SMSFORMAT
#SMSFORMAT – Select 3GPP or 3GPP2 format for MO SMS
SELINT 2
AT#SMSFORMAT=
<mode>[,<3GPP2PDUMode>
]
Set command selects the 3GPP or 3GPP2 format for MO SMS and
the input mode for 3GPP2 SMS when
+CMGS
is used in PDU mode.