Telit Wireless Solutions LE910 - Socket Configuration Extended 2 - #SCFGEXT2

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 333 of 509
Mod. 0808 2011-07 Rev.2
Socket configuration Extended 2 - #SCFGEXT2
#SCFGEXT2 - Socket Configuration Extended
AT#SCFGEXT2=
<connId>,<bufferStart>,
[,<abortConnAttempt>
[,<unused_B >
[,<unused_C >[,<noCarrierMode>]]]]
Set command sets the socket configuration extended parameters for
features not included in #SCFGEXT command.
Parameters:
<connId> - socket connection identifier
1..6
<bufferStart> - Set the sending timeout method based on new data
received from the serial port.
(<txTo> timeout value is set by #SCFG command)
Restart of transmission timer will be done when new data
are received from the serial port.
0 - old behaviour for transmission timer
(#SCFG command 6th parameter old behaviour,
start only first time if new data are received from the
serial port)
1 - new behaviour for transmission timer:
restart when new data received from serial port
Note: is necessary to avoid overlapping of the two methods.
Enabling new method, the old method for transmission timer(#SCFG) is
automatically disabled to avoid overlapping.
Note: check if new data have been received from serial port
is done with a granularity that is directly related to #SCFG <txTo> setting
with a maximum period of 1 sec.
<abortConnAttempt> - Enable connection attempt(#SD/#SKTD) abort
before CONNECT(online mode) or OK(command mode)
0 – Not possible to interrupt connection attempt
1 – It is possible to interrupt the connection attempt
(<connTo> set by #SCFG or
DNS resolution running if required)
and give back control to AT interface by
reception of a character.
As soon as the control has been given to the AT interface
the ERROR message will be received on the interface itself.
Note: values are automatically saved in NVM.
<noCarrierMode> - permits to choose NO CARRIER