Telit Wireless Solutions LE910 - Handset Microphone Gain - #HSMICG; Handset Receiver Gain - #HSRECG; Handsfree Receiver Gain - #HFRECG

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 447 of 509
Mod. 0808 2011-07 Rev.2
#HFMICG - Handsfree Microphone Gain
SELINT 2
AT#HFMICG=
[<level>]
It has no effect and is included only for backward compatibility.
Parameter:
<level>: 0..7 - (factory default = 4)
AT#HFMICG?
Read command returns the current set value for parameter <level>, in the format:
#HFMICG: <level>
AT#HFMICG=?
Test command returns the supported range of values of parameter <level>.
Handset Microphone Gain - #HSMICG
#HSMICG - Handset Microphone Gain
SELINT 2
AT#HSMICG=
[<level>]
Set command sets the handset microphone input gain
Parameter:
<level>: handset microphone input gain
0..7 - handset microphone gain (+6dB/step)
AT#HSMICG?
Read command returns the current handset microphone input gain, in the format:
#HSMICG: <level>
AT#HSMICG=?
Test command returns the supported range of values of parameter <level>.
Handsfree Receiver Gain - #HFRECG
#HFRECG - Handsfree Receiver Gain
SELINT 2
AT#HFRECG=
<level>
It has no effect and is included only for backward compatibility.
Parameter:
<level>:
0..6 - (factory default = 0)
Note: This parameter is saved in NVM issuing AT&W command.
AT#HFRECG?
Read command returns the current value of parameter <level>, in the format:
#HFRECG: <level>
AT#HFRECG =?
Test command returns the supported range of values of parameter <level>.
Handset Receiver Gain - #HSRECG
#HSRECG - Handset Receiver Gain
SELINT 2
AT#HSRECG=
Set command sets the handset analogue output gain