Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 495 of 509
Mod. 0808 2011-07 Rev.2
#SWMENA – SWM Client Enable / Disable
#SWMENA: 0,0
OK
AT#SWMENA=1
OK
AT#SWMENA?
AT#SWMENA: 1,0
OK
Configure SWM Client Parameters - #SWMCFG
#SWMCFG – Configure SWM Client Parameters
size_ext_storage>
[,<pdpId>[,<enableInRoamin
g>[,<enableReleaseNoteURL
>[,<pollingIntervalInHours>[
,<bootupPollingInterval>[,<r
ecoveryPollingInterval>[,<sec
ureConnection>]]]]]]]
Set command configures the parameters related to SWM Client.
Parameters:
<max_avail_size_ext_storage> - maximum available size in bytes of the
external storage. For external application updates. Default: 0.
<pdpId> - PDP context identifier the SWM client should use on the
module. Range: 1-5; Default: 1
<enableInRoaming> - Flag indicating if DM sessions are allowed in
cellular roaming conditions.
0 – DM sessions not allowed in roaming (default)
1 – DM sessions allowed in roaming
<enableReleaseNoteURL> - Flag indicating if unsolicited ring
notifications for #SWMCHKUPD and #SWMRING will contain the
release note strings even if they are present in the DM session.
0 – release note not present in URC (default)
1 – release note present in URC
<pollingIntervalInHours> - Integer parameter indicating the span of time
in hours between automatic DM session initiations by the SWM client.
Valid value is >=0. A value of 0 means no polling. Default is stored parsed
as part of the DM tree: 168.
<bootupPollingInterval> - Integer parameter indicating the span of time
in minutes between device boot and a one time DM session initiation by
To Next Page
Loading...
Need help?
General
