Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 147 of 509
Mod. 0808 2011-07 Rev.2
+CGACT - PDP Context Activate Or Deactivate
Note: if no <cid>s are specified, the activation form of the command activates the
first three defined contexts. The deactivation form deactivates all the active
Read command returns the current activation state for all the defined PDP contexts
in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
Test command reports information on the supported PDP context activation states
parameters in the format:
OK
AT+CGACT?
+CGACT: 1,1
3G Quality Of Service Profile (Negotiated) - +CGEQNEG
+CGEQNEG – 3G Quality Of Service Profile (Negotiated)
[<cid>[,<cid>[,…]]]
This command allows the TE to retrieve the negotiated 3G quality of service
returned in the Activate PDP Context Accept/Modify message.
Set command returns the negotiated 3G QoS profile for the specified
context identifiers, <cid>s. The Qos profile consi
parameters, each of which may have a separate value.
Parameters:
<cid> - PDP context identification (see +CGDCONT command).
It returns the current settings for each specified context in the format (see
+CGEQREQ):
[+CGEQNEQ: <cid>,
<Traffic class>,<Maximum bitrate
UL>,<Maximum bitrate DL>,<Guaranteed bitrate UL>,<Guaranteed
bitrate DL>,<Delivery order>,<Maximum SDU size>,<SDU error
ratio>,<Residual bit error ratio>,<Delivery of erroneous
SDUs>,<Transfer delay>,<Traffic handling><CR><LF>]
[+CGEQNEQ:…]
Test command returns a list of <cid>s associated with active contexts.
To Next Page
Loading...
Need help?
General
