Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 146 of 509
Mod. 0808 2011-07 Rev.2
2 - interactive
3 – background
<Traffic handling priority >
- Traffic handling priority
0 (default value as undefined)
1…3
If no PDP context has been defined, it has no effect and OK result
Test command returns as a compound value the type of the current
PDP context and the supported values for the subparameters in the
format:
+CGQMIN: <PDP_Type>,(list of supported <Traffic class>s),
(list of supported <Maximum bitrate UL>s),(list of supported
<Maximum bitrate DL>s),(list of supported <Guaranteed bitrate
UL>s),(list of supported <Guaranteed bitrate DL>s),(list of
supported <Delivery order>s),(list of supported<Maximum SDU
size>s),(list of supported<SDU error ratio>s),(list of
supported<Residual bit error ratio>s),(list of supported
<Delivery of erroneous SDUs>s),(list of supported <Transfer
delay>s),(list of supported <Traffic handling priority>s), (list of
supported <Source statistics descriptor>s), (list of supported
<Signalling indication>s)
Note: only the “IP” PDP_Type is currently supported.
This command is not supported in LTE-only variants
PDP Context activate or deactivate - +CGACT
+CGACT - PDP Context Activate Or Deactivate
[<state>[,<cid>
[,<cid>[,…]]]]
Execution command is used to activate or deactivate the specified PDP context(s)
Parameters:
<state> - indicates the state of PDP context activation
0 - deactivated
1 - activated
<cid> - a numeric parameter which specifies a particular PDP context definition
(see +CGDCONT command)
Note: only three <cid>s can be activated at the same time.
To Next Page
Loading...
Need help?
General
