Telit Wireless Solutions LE910 - Codec Information - #CODECINFO

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 264 of 509
Mod. 0808 2011-07 Rev.2
Codec Information - #CODECINFO
#CODECINFO – Codec Information
SELINT 2
AT#CODECINFO[
=<format>[,
<mode>]]
This command is both a set and an execution command.
Set command enables/disables codec information reports depending on the
parameter <mode>, in the specified <format>.
Parameters:
<format>
0 – numeric format (default)
1 – textual format
<mode>
0 - disable codec information unsolicited report (default)
1 - enable codec information unsolicited report only if the codec changes
2 - enable short codec information unsolicited report only if the codec changes
If <mode>=1 the unsolicited channel mode information is reported in the
following format:
(if <format>=0)
#CODECINFO: <codec_used>,<codec_set>
(if <format>=1)
#CODECINFO: <codec_used>,<codec_set1>
[,<codec_set2>[..[,codec_setn]]]
If <mode>=2 the unsolicited codec information is reported in the following
format:
#CODECINFO: <codec_used>
The reported values are described below.
Execution command reports codec information in the specified <format>.
(if <format>=0)
#CODECINFO: <codec_used>,<codec_set>
(if <format>=1)
#CODECINFO: <codec_used>,<codec_set1>
[,<codec_set2>[..[,codec_setn]]]
The reported values are:
(if <format>=0)