Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 88 of 509
Mod. 0808 2011-07 Rev.2
+CLCC - List Current Calls
SS Notification - +CSSN
[,<m>]]
It refers to supplementary service related network initiated notifications.
Set command enables/disables the presentation of notification result codes from TA
to TE.
Parameters:
<n> - sets the +CSSI result code presentation status
0 - disable
1 - enable
<m> - sets the +CSSU result code presentation status
0 - disable
1 - enable
When <n>=1 and a supplementary service notification is received after a mobile
originated call setup, an unsolicited code:
+CSSI: <code1>
is sent to TE before any other MO call setup result codes, where:
<code1>:
0 - unconditional call forwarding is active
1 - some of the conditional call forwardings are active
2 - call has been forwarded
3 - call is waiting
5 - outgoing calls are barred
6 - incoming calls are barred
When <m>=1 and a supplementary service notification is received during a mobile
terminated call setup or during a call, an unsolicited result code:
+CSSU: <code2>
is sent to TE, where:
<code2>:
0 - this is a forwarded call (MT call setup)
2 - call has been put on hold (during a voice call)
3 - call has been retrieved (during a voice call).
Read command reports the current value of the parameters.
Test command reports the supported range of values for parameters <n>, <m>.