Telit Wireless Solutions LE910 - E-Mail SMTP Port - #ESMTPPORT

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 417 of 509
Mod. 0808 2011-07 Rev.2
…data received on the serial port are sent as attachment….
Send escape sequence to close the SMTP connection
+++
NO CARRIER
at#smtpcl="me@myaddress.com","test2",2,"image.jpg",1
>message body...this is the text of the mail message…
Send CTRL-Z
CONNECT
…data received on the serial port are base64-encoded and sent as
attachment….
Send escape sequence to close the SMTP connection
+++
NO CARRIER
E-mail SMTP Port - #ESMTPPORT
#ESMTPPORT – E-mail SMTP Port
SELINT 2
AT#ESMTPPORT=<Port>
This command permits to set SMTP port
Parameters:
<Port> - SMTP port to contact (default 25)
25..465,587
Note: SMTP protocol is used on the selected port
Note: the value set by command is directly stored in NVM
AT#ESMTPPORT?
Read command reports the currently selected <Port> in the format:
#ESMTPPORT: <Port >
AT#ESMTPPORT=?
Test command reports the supported range of values for parameter < Port >