Telit Wireless Solutions LE910 - Event Monitoring - #EVMONI

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 316 of 509
Mod. 0808 2011-07 Rev.2
Event Monitoring - #EVMONI
#EVMONI – Set the single Event Monitoring
SELINT 2
AT#EVMONI=
<label>,
<mode>,
[,<paramType >
,<param>]
Set command enables/disables the single event monitoring, configures the related
parameter and associates the AT command
<label>: string parameter (that has to be enclosed between double quotes)
indicating the event under monitoring. It can assume the following values:
• VBATT - battery voltage monitoring
• DTR - DTR monitoring
• ROAM - roaming monitoring
• CONTDEACT - context deactivation monitoring
• RING - call ringing monitoring
• STARTUP – module start-up monitoring
• REGISTERED – network registration monitoring
• GPIO1 – monitoring on a selected GPIO in the GPIO range
• GPIO2 – monitoring on a selected GPIO in the GPIO range
• GPIO3 – monitoring on a selected GPIO in the GPIO range
• GPIO4 – monitoring on a selected GPIO in the GPIO range
• GPIO5 – monitoring on a selected GPIO in the GPIO range
• ADCH1 – ADC High Voltage monitoring
• ADCL1 – ADC Low Voltage monitoring
• DTMF1 –monitoring on user defined DTMF string
• DTMF2 –monitoring on user defined DTMF string
• DTMF3 –monitoring on user defined DTMF string
• DTMF4 –monitoring on user defined DTMF string
• SMSIN – monitoring on incoming SMS
• CONSUME1 – used to define an action to be used in consume functionality
(see parameter <action_id> in #CONSUMECFG command)
• CONSUME2 – used to define an action to be used in consume functionality
(see parameter <action_id> in #CONSUMECFG command)
• CONSUME3 – used to define an action to be used in consume functionality
(see parameter <action_id> in #CONSUMECFG command)
• CONSUME4 – used to define an action to be used in consume functionality
(see parameter <action_id> in #CONSUMECFG command)
• CONSUME5 – used to define an action to be used in consume functionality
(see parameter <action_id> in #CONSUMECFG command)
<mode>:
0 – disable the single event monitoring (default)
1 – enable the single event monitoring
< paramType >: numeric parameter indicating the type of parameter contained in
<param>. The 0 value indicates that <param> contains the AT command string to