Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 69 of 509
Mod. 0808 2011-07 Rev.2
Network Registration Report - +CREG
+CREG - Network Registration Report
SELINT 2
AT+CREG=
[<mode>]
Set command enables/disables network registration reports depending on the
parameter <mode>.
Parameter:
<mode>
0 - disable network registration unsolicited result code (factory default)
1 - enable network registration unsolicited result code
2 - enable network registration unsolicited result code with network Cell
identification data
If <mode>=1, network registration result code reports:
+CREG: <stat>
where
<stat>
0 - not registered, ME is not currently searching a new operator to register to
1 - registered, home network
2 - not registered, but ME is currently searching a new operator to register to
3 - registration denied
4 -unknown
5 - registered, roaming
If <mode>=2, network registration result code reports:
+CREG: <stat>[,<Lac>,<Ci>[,<AcT>]]
where:
<Lac> - Local Area Code (when <AcT> indicates value 0
to 6) or tracking area code (when <AcT> indicates value 7)
<Ci> - Cell Id for the currently registered on cell
<AcT>: access technology of the registered network:
0 GSM
2 UTRAN
3 GSM w/EGPRS
4 UTRAN w/HSDPA
5 UTRAN w/HSUPA
6 UTRAN w/HSDPA and HSUPA
7 E-UTRAN
Note: <Lac>, <Ci> and <AcT> are reported only if <mode>=2 and the mobile is
registered on some network cell.

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English