To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

#V24 - V24 Output Pins Control

SELINT 2

0 - Low

1 - High

Note: if <state> is omitted the command returns the actual state of the pin <pin>.

AT#V24?

Read command returns actual state for all the pins (either output and input) in the

format:

#V24: <pin1>,<state1>[<CR><LF>

#V24: <pin2>,<state2>[...]]

where

<pinn> - AT command serial port interface HW pin

<staten> - AT commands serial port interface hardware pin state

AT#V24=?

Test command reports supported range of values for parameters <pin> and <state>.

Battery and charger status - #CBC

#CBC- Battery And Charger Status

SELINT 2

AT#CBC

Execution command returns the current Battery and Charger state in the format:

#CBC: <ChargerState>,<BatteryVoltage>

where:

<ChargerState> - battery charger state

0 - charger not connected

1 - charger connected and charging

2 - charger connected and charge completed

<BatteryVoltage> - battery voltage in units of ten millivolts: it is the real battery

voltage only if charger is not connected; if the charger is connected this value

depends on the charger voltage.

AT#CBC=?

Test command returns the OK result code.

GPRS Auto-Attach Property - #AUTOATT

#AUTOATT - Auto-Attach Property

SELINT 2

AT#AUTOATT=

[<auto>]

Set command enables/disables the TE GPRS auto-attach property.

Telit Wireless Solutions LE910 User Manual

Questions and Answers: