Telit Wireless Solutions LE910 - FTP at Commands; FTP Time-Out

To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

#SSLI: <SSId>,<DataSent>,<DataRecv>,<PendingData>,<TCPConnWaitingAck>

where:

<SSId>

- secure socket connection identifier, as before

<DataSent> - total amount(in bytes) of data sent to the TLS/SSL connection since the

beginning of the connection itself

(obviously: not yet encoded into TLS/SSL record)

<DataRecv> - total number of bytes received from the TLS/SSL connection since

the beginning of the connection itself

(obviously: already decoded from TLS/SSL record)

<PendingData> - number of bytes available to be read from the TLS/SSL

record that is currently being processed

(obviously: already decoded from TLS/SSL record)

<TCPConnWaitingAck> - indication of the underlying TCP socket

condition, if there are TCP/IP packets sent but not yet acknowledged or not

0 – no TCP/IP packets sent waiting for ack

1 – yes TCP/IP packets sent waiting for ack

AT#SSLI=?

Test command returns the range of supported values for all the parameters.

#SSLI: (1)

4.1.6.7. FTP AT Commands

FTP Time-Out - #FTPTO

#FTPTO - FTP Time-Out

SELINT 2

AT#FTPTO=

[<tout>]

Set command sets the time-out used when opening either the FTP control channel

or the FTP traffic channel.

Parameter:

<tout> - time-out in 100 ms units

100..5000 - hundreds of ms (factory default is 100)

Note: The parameter is not saved in NVM.

AT#FTPTO?

Read command returns the current FTP operations time-out, in the format:

Telit Wireless Solutions LE910 - FTP at Commands; FTP Time-Out - #FTPTO