Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 347 of 509
Mod. 0808 2011-07 Rev.2
#SRECV - Receive Data In Command Mode
Read in hexadecimal format the buffered data
AT#SRECV=2,15
#SRECV: 2,15
737472696e67612064692074657374
OK
Or:
if the received datagram, received from <IPaddr and <IPport> is of 60 bytes
AT#SRECV=2,15
#SRECV: <IPaddr>,<IPport>,2,15,45
737472696e67612064692074657374
OK
SRING URC (<srMode> be 2, <dataMode> be 0) displaying (in text format) 15 bytes data
that have just come through connected socket identified by <connId>=3; it’s no
necessary to issue #SRECV to read the data; no data remain in the buffer after this
URC
SRING: 3,15, stringa di test
Send Data In Command Mode - #SSEND
#SSEND - Send Data In Command Mode
<connId>
Execution command permits, while the module is in command mode, to send
data through a connected socket.
Parameters:
<connId> - socket connection identifier
1..6
The device responds to the command with the prompt
<greater_than><space>
and waits for the data to send.
To complete the operation send Ctrl-Z char (0x1A hex); to exit without writing
the message send ESC char (0x1B hex).
If data are successfully sent, then the response is OK.
If data sending fails for some reason, an error code is reported
Note: the maximum number of bytes to send is 1500 bytes
; trying to send more data will cause the surplus to be discarded and lost.
To Next Page
Loading...
Need help?
General
