Telit Wireless Solutions LE910 - Network Registration Status - +CGREG

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 130 of 509
Mod. 0808 2011-07 Rev.2
+CGEREP - GPRS Event Reporting
SELINT 2
+CGEV: ME DETACH
The mobile equipment has forced a GPRS detach. This implies that all active
contexts have been deactivated. These are not reported separately
+CGEV: ME CLASS <class>
The mobile equipment has forced a change of MS class. The highest available
class is reported (see +CGCLASS)
AT+CGEREP?
Read command returns the current <mode> and <bfr> settings, in the format:
+CGEREP: <mode>,<bfr>
AT+CGEREP=?
Test command reports the supported range of values for the +CGEREP command
parameters.
Reference
3GPP TS 27.007
Network Registration Status - +CGREG
+CGREG - GPRS Network Registration Status
SELINT 2
AT+CGREG=[<n>]
Set command controls the presentation of an unsolicited result code
+CGREG: (see format below).
Parameter:
<n> - result code presentation mode
0 - disable network registration unsolicited result code
1 - enable network registration unsolicited result code; if there is a change in the
terminal GPRS network registration status, it is issued the unsolicited result
code:
+CGREG: <stat>
where:
<stat> - registration status
0 - not registered, terminal is not currently searching a new operator to register
to
1 - registered, home network
2 - not registered, but terminal is currently searching a new operator to register
to
3 - registration denied
4 - unknown
5 - registered, roaming
2 - enable network registration and location information unsolicited result code; if
there is a change of the network cell, it is issued the unsolicited result code:
+CGREG: <stat>[,<lac>,<ci>[,<AcT>,<rac>]]