Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 154 of 509
Mod. 0808 2011-07 Rev.2
Preferred Message Storage - +CPMS
+CPMS - Preferred Message Storage
<memr>
[,<memw>
[,<mems>]]
Set command selects memory storages <memr>, <memw> and <mems> to be
used for reading, writing, sending and storing SMs.
Parameters:
<memr> - memory from which messages are read and deleted
"SM" - SIM SMS memory storage (default)
“ME” – NVM SMS storage
<memw> - memory to which writing and sending operations are made
"SM" - SIM SMS memory storage (default)
“ME” – NVM SMS storage
<mems> - memory to which received SMs are preferred to be stored
"SM" - SIM SMS memory storage (default)
“ME” – NVM SMS storage
The command returns the memory storage status in the format:
+CPMS: <usedr>,<totalr>,<usedw>,<totalw>,<useds>,<totals>
where:
<usedr> - number of SMs stored into <memr>
<totalr> - max number of SMs that <memr> can contain
<usedw> - number of SMs stored into <memw>
<totalw> max number of SMs that <memw> can contain
<useds> - number of SMs stored into <mems>
<totals> - max number of SMs that <mems> can contain
Note: when <memr> is set to a memory, also <memw> and <mems> are set to the
same memory.
Note: the set memory is automatically saved in NVM.
Read command reports the message storage status in the format:
+CPMS: <memr>,<usedr>,<totalr>,<memw>,<usedw>,<totalw>,
<mems>,<useds>,<totals>
where <memr>, <memw> and <mems> are the selected storage memories for
reading, writing and storing respectively.
Test command reports the supported values for parameters <memr>, <memw> and
<mems>
+CPMS: "SM",5,10,"SM",5,10,"SM",5,10
OK
(you have 5 out of 10 SMS SIM positions occupied)
To Next Page
Loading...
Need help?
General
