Telit Wireless Solutions LE910 - USB Configuration - #USBCFG

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 187 of 509
Mod. 0808 2011-07 Rev.2
USB configuration - #USBCFG
#USBCFG- USB Configuration
SELINT 2
AT#USBCFG=<mode>
Set command specify USB configuration on the modem device.
New configuration mode applied at the next boot up time.
Parameter:
<mode>
- USB configuration mode
0 – All the USB ports (Telit Mobile (USBx) are in ACM mode;
Selective Suspend is disabled; ECM is disabled; DLINK feature is
disabled; VID 0x1BC7 PID 0x0021
(default value)
1 – All the USB ports (Telit Mobile (USBx) are in ACM Data Only
mode (2 endpoints for each port); Selective Suspend is disabled;
ECM is disabled; DLINK feature is enabled; VID 0x1BC7 PID 0x0026
2 – All the USB ports (Telit Mobile (USBx) are in ACM mode;
Selective Suspend is disabled; ECM is disabled; DLINK feature is
enabled; VID 0x1BC7 PID 0x0021
3 – All the USB ports (Telit Mobile (USBx) are in ACM mode;
Selective Suspend is disabled; ECM is enabled; DLINK feature is
disabled; VID 0x1BC7 PID 0x0023
4 – All the USB ports (Telit Mobile (USBx) are in ACM mode;
Selective Suspend is enabled; ECM is disabled; DLINK feature is
disabled; VID 0x1BC7 PID 0x0024
5 – All the USB ports (Telit Mobile (USBx) are in ACM mode;
Selective Suspend is enabled; ECM is enabled; DLINK feature is
disabled; VID 0x1BC7 PID 0x0023
Note: the modem device doesn’t reset automatically; use
AT#REBOOT or a complete power cycle.
Note: the default value depends on the software version
Note: to learn more about DLINK feature, read AT#DLINK
description
Mode
Ports
SS
ECM
DLINK
VID
PID
0
ACM
NO
NO
NO
0x1BC7
0x0021
1
ACM Data Only
NO
NO
YES
0x1BC7
0x0026