Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 315 of 509
Mod. 0808 2011-07 Rev.2
EvMoni Service parameter - #ENAEVMONICFG
#ENAEVMONICFG – Set EvMoni Service Parameters
<instance>
[,<urcmod>
[,<timeout>]]
Set command configures the EvMoni service.
Parameter:
<instance>:
AT instance that will be used by the service to run the AT Command. Range 1
- 5. (Default: 3)
<urcmod>:
0 – disable unsolicited message
1 - enable an unsolicited message when an AT command is executed
after an event is occurred (default)
When unsolicited is enabled, the AT Command is indicated to TE with
unsolicited result code:
#EVMONI: <Text>
e.g.:
#EVMONI: AT+CGMR;+CGSN;+GSN;+CCLK
Unsolicited is dumped on the instance that requested the service activation.
<timeout>:
It defines in minutes the maximum time for a command execution. If timeout
expires the module will be rebooted. (Default: 5)
Note 1: the current settings are stored in NVM.
Note 2: the instance used for the EvMoni service is the same used for the SMS
AT RUN service. Therefore, when the #ENAEVMONICFG sets the
<instance> parameter, the change is reflected also in the <instance> parameter
of the #SMSATRUNCFG command, and viceversa.
Note 3: the set command returns ERROR if the command AT#ENAEVMONI?
returns 1 as <mod> parameter or the command AT#SMSATRUN? returns 1 as
Read command returns the current settings of parameters in the format:
#ENAEVMONICFG:<instance>,<urcmod>,<timeout>
Test command returns the supported values for the ENAEVMONICFG
parameters
To Next Page
Loading...
Need help?
General
