Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 314 of 509
Mod. 0808 2011-07 Rev.2
#ENAEVMONI – Enable EvMoni Service
Parameter:
< mod >
0: Service Disabled (default)
1: Service Enabled
Note1: When the service is active on a specific AT instance, that instance
cannot be used for any other scope, except for OTA service that has the highest
priority. For example in the multiplexer request to establish the Instance, the
request will be rejected.
Note2: the current settings are stored in NVM.
Read command returns the current settings of <mode> and the value of <stat>
in the format:
# ENAEVMONI: <mod>,<stat>
where:
<stat> - service status
0 – not active (default)
1 - active
Test command returns the supported values for the ENAEVMONI parameters
To Next Page
Loading...
Need help?
General
