Telit Wireless Solutions LE910 - Message Waiting Indication - #MWI

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 237 of 509
Mod. 0808 2011-07 Rev.2
#MBN - Mailbox Numbers
SELINT 2
Note: if all queried locations are empty (but available), no information text lines
will be returned.
AT#MBN=?
Test command returns the OK result code.
Message Waiting Indication - #MWI
#MWI - Message Waiting Indication
SELINT 2
AT#MWI=<enable>
Set command enables/disables the presentation of the message waiting indicator
URC.
Parameter:
<enable>
0 - disable the presentation of the #MWI URC
1 - enable the presentation of the #MWI URC each time a new message waiting
indicator is received from the network and, at startup, the presentation of the
status of the message waiting indicators, as they are currently stored on SIM..
The URC format is:
#MWI: <status>,<indicator>[,<count>]
where:
<status>
0 - clear: it has been deleted one of the messages related to the indicator
<indicator>.
1 - set: there’s a new waiting message related to the indicator <indicator>
<indicator>
1 - either Line 1 (CPHS context) or Voice (3GPP context)
2 - Line 2 (CPHS context only)
3 - Fax
4 - E-mail
5 - Other
<count> - message counter: network information reporting the number of pending
messages related to the message waiting indicator <indicator>.
The presentation at startup of the message waiting indicators status, as they are
currently stored on SIM, is as follows:
#MWI: <status>[,<indicator>[,<count>][<CR><LF>
#MWI: <status>,<indicator>[,<count>][...]]]
where:
<status>