EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 206 of 509
Mod. 0808 2011-07 Rev.2
Save STAT_LED GPIO Setting - #SLEDSAV
#SLEDSAV - Save STAT_LED GPIO Setting
SELINT 2
AT#SLEDSAV
Execution command saves STAT_LED setting in NVM.
AT#SLED=?
Test command returns OK result code.
SMS Ring Indicator - #E2SMSRI
#E2SMSRI - SMS Ring Indicator
SELINT 2
AT#E2SMSRI=
[<n>]
Set command enables/disables the Ring Indicator pin response to an incoming SMS
message. If enabled, a negative going pulse is generated on receipt of an incoming
SMS message. The duration of this pulse is determined by the value of <n>.
Parameter:
<n> - RI enabling
0 - disables RI pin response for incoming SMS messages (factory default)
50..1150 - enables RI pin response for incoming SMS messages. The value of <n>
is the duration in ms of the pulse generated on receipt of an incoming SM.
Note: if +CNMI=3,1 command is issued and the module is in a GPRS connection,
a 100 ms break signal is sent and a 1 sec. pulse is generated on RI pin, no matter if
the RI pin response is either enabled or not.
AT#E2SMSRI?
Read command reports the duration in ms of the pulse generated on receipt of an
incoming SM, in the format:
#E2SMSRI: <n>
Note: as seen before, the value <n>=0 means that the RI pin response to an
incoming SM is disabled.
AT#E2SMSRI=?
Reports the range of supported values for parameter <n>
Event Ring Indicator - #E2RI
#E2RI – Event Ring Indicator
SELINT 2
AT#E2RI=<event_mask>,<du
ration>
Set command enables/disables the Ring Indicator pin response to one or
more events. If an event has been enabled, a negative going pulse is
generated when event happens. The duration of this pulse is determined by
the value of <duration>.
Parameters:
<event_mask> :
0 – disables all events
hexadecimal number representing the list of events: 1Power Saving
Mode
2 – Socket Listen (same as AT#E2SLRI=<duration>)
4 – OTA firmware upgrade (same as AT#OTASETRI=<duration>)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals