Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 207 of 509
Mod. 0808 2011-07 Rev.2
8 – MT SMS has been received (same as AT#E2SMSRI=<duration>)
10 – +CREG will change status
20 – +CGREG will change status
40 – #QSS become 2 (SIM INSERTED and PIN UNLOCKED)
80 – MO SMS has been delivered
100 – Jamming Detection & Reporting (JDR)
The hexadecimal number is actually a bit mask, where each bit, when
set/not set, indicates that the corresponding event has been
enabled/disabled.
<duration> :
50..1150 - the duration in ms of the pulse generated
Note: The values set by the command are stored in the profile extended
section and they don’t depend on the specific AT instance.
Note: Enabling JDR event when the Enhanced Jamming Detection &
Reporting feature has been previously enabled (see #JDRE and
Read command reports a line for each event and the duration in ms of the
pulse generated, in the format:
#E2RI: <event_mask>,<duration>
Test command returns supported values ofparameters <event_mask> and <duration>
To Next Page
Loading...
