Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 90 of 509
Mod. 0808 2011-07 Rev.2
+CPOL - Preferred Operator List
<E-UTRAN_AcTn> - E-UTRAN access technology:
0 access technology not selected
1 access technology selected
Note: if <index> is given but <oper> is left out, entry is deleted. If <oper>
is given but <index> is left out, <oper> is put in the next free location. If
only <format> is given, the format of the <oper> in the read command is
Read command returns all used entries from the SIM list of preferred
operators.
Test command returns the whole <index> range supported by the SIM and
the range for the parameter <format>
Selection of preferred PLMN list - +CPLS
+CPLS – Selection of preferred PLMN list
The execution command is used to select a list of preferred PLMNs in the
SIM/USIM.
Parameters:
<list>:
0 - User controlled PLMN selector with Access Technology
EFPLMNwAcT, if not found in the SIM/UICC then PLMN
preferred list EFPLMNsel (this file is only available in SIM card or
GSM application selected in UICC)
1 - Operator controlled PLMN selector with Access Technology
EFOPLMNwAcT
2 - HPLMN selector with Access Technology EFHPLMNwAcT
Note: the value set by command is directly stored in NVM and doesn’t
depend on the specific CMUX instance.
Read command returns the selected PLMN selector <list> from the
SIM/USIM.
Test command returns the whole index range supported <list>s by the
SIM/USIM.
To Next Page
Loading...
Need help?
General
