Telit Wireless Solutions LE910 - Handsfree Microphone Gain - #HFMICG; Select Ringer Path - #SRP

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 446 of 509
Mod. 0808 2011-07 Rev.2
#SRS - Select Ringer Sound
SELINT 2
Note: if command is issued with <n> > 0 and <tout> = 0, the playing of the ringing
is stopped (if present) and <n> ringing tone is set as current.
Note: if command is issued with <n> = 0 and <tout> > 0 then the current ringing
tone is played for <tout> seconds.
Note: if both <n> and <tout> are 0 then the default ringing tone is set as current
and ringing is stopped.
Note: If all parameters are omitted then the behaviour of Set command is the same
as Read command
AT#SRS?
Read command reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> - ringing tone number
1..max
<status> - ringing status
0 - selected but not playing
1 - currently playing
AT#SRS=?
Test command reports the supported values for the parameters <n> and <tout>
Select Ringer Path - #SRP
#SRP - Select Ringer Path
SELINT 2
AT#SRP=[<n>]
It has no effect and is included only for backward compatibility.
Parameter:
<n>: (0-3)
AT#SRP?
Read command reports the set value of the parameter <n> in the format:
#SRP: <n>.
AT#SRP=?
Test command reports the supported values for the parameter <n>.
Example
AT#SRP=?
#SRP: (0-3)
OK
AT#SRP=3
OK
Handsfree Microphone Gain - #HFMICG