Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 211 of 509
Mod. 0808 2011-07 Rev.2
#AUTOATT - Auto-Attach Property
<auto>
0 - disables GPRS auto-attach property
1 - enables GPRS auto-attach property (factory default): after the command
#AUTOATT=1 has been issued (and at every following startup) the terminal
will automatically try to attach to the GPRS service.
Read command reports whether the auto-attach property is currently enabled or not,
in the format:
Test command reports available values for parameter <auto>.
Cell Monitor - #MONI
[<number>]]
#MONI is both a set and an execution command.
Set command sets one cell out of seven, in the neighbour list of the serving cell
including it, from which extract GSM /UMTS-related information.
Parameter:
<number>
(GSM network)
0..6 - it is the ordinal number of the cell, in the neighbour list of the serving cell
(default 0, serving cell).
7 - it is a special request to obtain GSM-related information from the whole set of
seven cells in the neighbour list of the serving cell.
(UMTS network)
0 – it is the serving cell in idle; Active set cells are also reported in CELL_DCH
state, i.e. during a call (default)
1 – it is the candidate set ( cells that belong to the Active set, only reported in
CELL_DCH state, i.e. during a call)
2 – it is the synchronized neighbour set (cells that belong to the Virtual Active set,
only reported in CELL_DCH state, i.e. during a call)
3 –
it is the asynchronized neighbour set (cells which are not suitable cells to camp
on)
4 – it is the ranked neighbour set (cells which are suitable cells to camp on)
7 - it is a special request to obtain information from the whole set of detected cells
in the neighbour list of the serving cell.
5..6 – it is not available
To Next Page
Loading...
Need help?
General
