To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

+CEREG – EPS network registration status

SELINT 2

+CEREG: (list of supported <n>s)

Reference

3GPP TS 27.007

Set Mode of operation for EPS - +CEMODE

+CEMODE – Set mode of operation for EPS.

AT+CEMODE=[<mode>]

Set command configures the mode of operation for EPS

Parameter:

<mode>:

a numeric parameter which indicates the mode of operation

0 : PS mode 2 of operation

1 : CS/PS mode 1 of operation

2 : CS/PS mode 2 of operation

3 : PS mode 1 of operation

NOTE:

the definition for UE modes of operation can be found in

3GPP TS 24.301 [83]

Other values are reserved and will result in an ERROR response to the

set command.

AT+CEMODE?

Read command returns the currently configured values, in the format:

+CEMODE

< mode >

NOTE:

The read command will return right values after set command.

But effectively the mode of operation changes after power cycle.

AT+CEMODE=?

Test command returns the supported range of values of parameters <

mode>

+CEMODE: (0-3)

Note

Example

AT+CEMODE=1

AT+CEMODE?

+CEMODE: 1

Extended Signal Quality - +CESQ

Telit Wireless Solutions LE910 User Manual

Questions and Answers: