Telit Wireless Solutions LE910 - PDP Context Read Dynamic Parameters - +CGDCONTRDP

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 133 of 509
Mod. 0808 2011-07 Rev.2
+CGDCONT - Define PDP Context
SELINT 2
Note: a special form of the Set command,
+CGDCONT=<cid>
, causes the
values for context number
<cid>
to become undefined.
Note: parameters from <IPv4AddrAlloc> to <IM_CN_Signalling_Flag_Ind>
are shown in the Read command only if different from default.
AT+CGDCONT?
Read command returns the current settings for each defined context in the
format:
+CGDCONT: <cid>,<PDP_type>,<APN>,<PDP_addr>,<d_comp>,
<h_comp>[<CR><LF>+CGDCONT: <cid>,
<PDP_type>,<APN>,<PDP_addr>,<d_comp>,<h_comp>
[…]
AT+CGDCONT=?
Test command returns values supported as a compound value
Example
AT+CGDCONT=1,”IP”,”APN”,”10.10.10.10”,0,0
OK
AT+CGDCONT?
+CGDCONT: 1,”IP”,“APN”,”10.10.10.10”,0,0
OK
at+cgdcont=?
+CGDCONT: (1-5),"IP",,,0,(0,1,2,3,4),(0,1),(0,1),(0,1),(0,1)
+CGDCONT: (1-5),"IPV6",,,0,(0,1,2,3,4),(0,1),(0,1),(0,1),(0,1)
+CGDCONT: (1-5),"IPV4V6",,,0,(0,1,2,3,4),(0,1),(0,1),(0,1),(0,1)
OK
Reference
3GPP TS 27.007
PDP Context Read Dynamic Parameters - +CGDCONTRDP
+CGCONTRDP - PDP Context Read Dynamic Parameters
AT+CGCONTRDP=
[<p_cid>]
Possible response(s):
+CGCONTRDP: <p_cid>, <bearer_id>,
<apn>[, <ip_addr>, <subnet_mask>[,
<gw_addr>[, <DNS_prim_addr>[,
<DNS_sec_addr>[, <P-CSCF_prim_addr>[,
<P-CSCF_sec_addr>]]]]]]
[<CR><LF>
+CGCONTRDP: <p_cid>,
<bearer_id>, <apn>[, <ip_addr>,
<subnet_mask>[, <gw_addr>[,
<DNS_prim_addr>[, <DNS_sec_addr>[, <PCSCF_
prim_addr>[, <PCSCF_