Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 177 of 509
Mod. 0808 2011-07 Rev.2
Note: if message sending fails for some reason, an error code is reported.
Note: care must be taken to ensure that during the command execution, which may
take several seconds, no other SIM interacting commands are issued.
Note: it is possible to send a concatenation of at most 10 SMs; the maximum
number of chars depends on the <dcs>: 1520 chars if 3GPP TS 23.038 default
alphabet is used, 1330 chars if 8-bit is used, 660 chars if UCS2 is used. If entered
text is longer than this maximum value an error is raised
Test command resturns the OK result code.
To avoid malfunctions is suggested to wait for the +CMGS: <mr> or +CMS
ERROR: <err> response before issuing further commands.
Send Message From Storage - +CMSS
+CMSS - Send Message From Storage
<index>[,<da>
[,<toda>]]
Execution command sends to the network a message which is already stored in the
<memw> storage (see +CPMS) at the location <index>.
Parameters:
<index> - location value in the message storage <memw> of the message to send
<da> - destination address, string type represented in the currently selected
character set (see +CSCS); if it is given it shall be used instead of the one
stored with the message.
<toda> - type of destination address
129 - number in national format
145 - number in international format (contains the "+")
If message is successfully sent to the network then the result is sent in the format:
+CMSS: <mr>
where:
<mr> - message reference number.
If message sending fails for some reason, an error code is reported:
+CMS ERROR:<err>
Note: to store a message in the <memw> storage see command +CMGW.
Note: care must be taken to ensure that during the command execution, which may
take several seconds, no other SIM interacting commands are issued.
Test command resturns the OK result code.
To Next Page
Loading...
