To Next Page

To Previous Page

Telit LE910 V2 Series AT Commands

80446ST10707A Rev. 0– 2015-11-03

Mod. 0808 2011-07 Rev.2

#TEMPMON: <urcmode>,<action>[,<hyst_time>[,<GPIO>]]

AT#TEMPMON=?

Test command reports the supported range of values for parameters <mod>,

Note

The following table is describing the temperature levels.

Extreme Temperature Lower Bound

-30°C

Operating Temperature Lower Bound -10°C

Operating Temperature

Operating Temperature Upper Bound 55°C

Extreme Temperature Upper Bound 80°C

Temperature monitor configuration - #TEMPCFG

#TEMPCFG – Temperature monitor configuration

SELINT 2

AT#TEMPCFG=

[,<TempOpLowBound>

[,<TempOpUpBound>

[,<TempExUpBound>]]]

This parameter command manages the temperature range used by the

TEMPMON command

Parameters:

<TempExLowBound> - the extreme temperature lower limit

<TempOpLowBound> - the operating temperature lower limit

<TempOpUpBound> - the operating temperature upper limit

<TempExUpBound> - the extreme temperature upper limit

Note 1: The extreme temperature lower limit must not be lower than lower

limit (see TEMPMON for temperature limits);

Note 2: the operating temperature lower limit must be bigger than the

extreme temperature lower

limit, and not lower than its minimum admitted

value (see TEMPMON for temperature limits);

Note 3: the operating temperature upper limit must be bigger than the

operating temperature lower limit, and not lower than its minimum

admitted value (see TEMPMON for temperature limits);

Telit Wireless Solutions LE910 User Manual

Questions and Answers: