Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 305 of 509
Mod. 0808 2011-07 Rev.2
4.1.6.4. Consume commandsEvent Monitor Commands
Configure consume parameters - #CONSUMECFG
#CONSUMECFG – configure consume parameters
d>[,<service_type>[,<rule_ena
ble>[,<period>[,<limit_amoun
t>[,<action_id>]]]]]
This command sets the parameters related to the consume functionality
Parameters:
<rule_id>
Index of the rule to apply to a defined <service_type>
Range: (0-10)
The available rules are 10 and their identifier ranges from 1 to 10. The
special case of <rule_id>=0 is explained below in a note.
<service_type>
Type of service to count:
0 – No service (default)
1 – SMS Sent
2 – SMS Received
3 – Total SMS
4 – CS MO Calls
5 – CS MT Calls
6 – Total CS Calls
7 – IP All Data Sent
8 – IP All Data Received
9 – IP All Data
10 – IP All Data Sent (with Header)
11 – IP All Data Received (with Header)
12 – IP All Data (with Header)
<rule_enable>
Enable the counter on the rule
0 – rule disabled (default)
1 – rule enabled
<period>
Time period over which the service type data are counted:
0 – life (entire module life) (default)
1 – 8760 (hours)
<limit_amount>
Limit amount of data to count. 0 is default value and means no set limit: in
this case only the counter is active.
0 – 4294967295 KBytes, for <service_type>=7,8,9,10,11 and 12
0 – 65535 number of SMS, for <service_type>=1,2, and 3
0 – 65535 minutes, for <service_type>=4,5 and 6
To Next Page
Loading...
