Telit Wireless Solutions LE910 - Response Format - V

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 42 of 509
Mod. 0808 2011-07 Rev.2
Response Format - V
V - Response Format
SELINT 2
ATV[<n>]
Set command determines the contents of the header and trailer transmitted with
result codes and information responses. It also determines if result codes are
transmitted in a numeric form or an alphanumeric form (see [§3.2.3 Information
Responses And Result Codes] for the table of result codes).
Parameter:
<n>
0 - limited headers and trailers and numeric format of result codes
information responses
<text><CR><LF>
result codes
<numeric code><CR>
1 - full headers and trailers and verbose format of result codes (factory default)
information responses
<CR><LF>
<text><CR><LF>
result codes
<CR><LF>
<verbose code><CR><LF>
Note: the <text> portion of information responses is not affected by this setting.
Note: if parameter is omitted, the command has the same behaviour of ATV0
Reference
V25ter