Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 255 of 509
Mod. 0808 2011-07 Rev.2
Subscriber number - #SNUM
#SNUM – Subscriber Number
<index>[,<number>[,
<alpha>]]
Set command writes the MSISDN information related to the subscriber (own
number) in the EFmsisdn SIM file.
Parameter:
<index> - record number
The number of record in the EFmsisdn depends on the SIM. If only <index> value
is given, then delete the EFmsisdn record in location <index> is deleted.
<number> - string containing the phone number
<alpha> - alphanumeric string associated to <number>. Default value is empty
string (“”), otherwise the used character set should be the one selected with +CSCS.
The string could be written between quotes, the number of characters depends on
the SIM. If empty string is given (""), the corresponding <alpha> will be an empty
string.
Note: the command return ERROR if EFmsisdn file is not present in the SIM or if
MSISDN service is not allocated and activated in the SIM Service Table (see 3GPP
TS 11.11).
Test command returns the OK result code
SIM detection mode - #SIMDET
#SIMDET - SIM Detection Mode
<mode>
Set command specifies the SIM Detection mode
Parameter:
<mode> - SIM Detection mode
0 - ignore SIMIN pin and simulate the status ‘SIM Not Inserted’
1 - ignore SIMIN pin and simulate the status ‘SIM Inserted’
2 - automatic SIM detection through SIMIN Pin (default)
Note: with Sim-On-Chip products,
allows to switch between
internal and external SIM, as described below:
0 – switch to internal SIM
1 – switch to external SIM, ignore SIMIN pin.
2 – automatic external SIM detection through SIMIN Pin (default).
NOTE: with
=1, although SIMIN pin is ignored, SIM removal is
detected
To Next Page
Loading...
Need help?
General
