Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 254 of 509
Mod. 0808 2011-07 Rev.2
#SKIPESC - Skip Escape Sequence
[<mode>]
Set command enables/disables skipping the escape sequence +++ while transmitting
during a data connection.
Parameter:
mode
0 - doesn’t skip the escape sequence; its transmission is enabled (factory default).
1 - skips the escape sequence; its transmission is not enabled.
2 - skips the escape sequence; its transmission is not enabled. If there are data
pending in the receiving buffer from the serial port driver, they are deleted.
Note: in case of an FTP connection, the escape sequence is not transmitted, regardless
Read command reports whether escape sequence skipping is currently enabled or not,
in the format:
Test command reports supported range of values for parameter <mode>.
To Next Page
Loading...
Need help?
General
