Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 39 of 509
Mod. 0808 2011-07 Rev.2
4.1.3.2. DTE - Modem Interface Control
Command Echo - E
Set command enables/disables the command echo.
Parameter:
<n>
0 - disables command echo
1 - enables command echo (factory default) , hence command sent to the device
are echoed back to the DTE before the response is given.
Note: if parameter is omitted, the command has the same behaviour of ATE0
Quiet Result Codes - Q
Set command enables or disables the result codes.
Parameter:
<n>
0 - enables result codes (factory default)
1 - disables result codes
2 - disables result codes (only for backward compatibility)
Note: After issuing either ATQ1 or ATQ2 every information text transmitted in
response to commands is not affected
Note: if parameter is omitted, the command has the same behaviour of ATQ0
After issuing ATQ1 or ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response
Data Carrier Detect (DCD) Control - &C
&C - Data Carrier Detect (DCD) Control
Set command controls the RS232 DCD output behaviour.
Parameter:
<n>
0 - DCD remains high always.
To Next Page
Loading...
Need help?
General
