Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 34 of 509
Mod. 0808 2011-07 Rev.2
Store Current Configuration - &W
&W - Store Current Configuration
Execution command stores on profile <n> the complete configuration of the device.
Parameter:
<n>
0..1 - profile
Note: if parameter is omitted, the command has the same behaviour of AT&W0.
Store Telephone Number - &Z
&Z - Store Telephone Number In The Wireless Module Internal Phonebook
Execution command stores in the record <n> the telephone number <nr>. The
records cannot be overwritten, they must be cleared before rewriting.
Parameters:
<n> - phonebook record
<nr> - telephone number (string type)
Note: the wireless module has a built in non volatile memory in which 10 telephone
numbers of a maximum 24 digits can be stored
Note: to delete the record <n> the command AT&Z<n>=<CR> must be issued.
Note: the records in the module memory can be viewed with the command &N,
while the telephone number stored in the record n can be dialed by giving the
Display Stored Numbers - &N
&N - Display Internal Phonebook Stored Numbers
Execution command returns the telephone number stored at the <n> position in the
internal memory.
Parameter:
<n> - phonebook record number
Note: if parameter <n> is omitted then all the internal records are shown.
To Next Page
Loading...
Need help?
General
