Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 444 of 509
Mod. 0808 2011-07 Rev.2
4.1.6.14. Phonebook AT Commands Set
Read Group Entries - #CPBGR
#CPBGR- Read Group Entries
<index1>
[,<index2>]
Execution command returns Grouping information Alpha String (GAS) USIM file
entries in location number range <index1>...<index2>. If <index2> is omitted,
only location <index1> is returned. These strings are the names used for groups an
ADN entry could belong to.
Parameters:
<index1> - integer type, value in the range of location numbers of GAS.
<index2> - integer type, value in the range of location numbers of GAS.
The response format is:
[#CPBGR: <index1>,<text>[<CR><LF>
#CPBGR: <index2>,<text>[…]]]
where:
<indexn> - the location number of the GAS entry
<text> - the alphanumeric text associated to the entry
Test command returns the supported range of values for parameters <indexn> and
the maximum length of <text> field, in the format:
#CPBGR: (<minIndex> - <maxIndex>),<tlength>
where:
<minIndex> - the minimum <index> number, integer type
<maxIndex>- the maximum <index> number, integer type
<tlength> - maximum <text> field length, integer type
To Next Page
Loading...
Need help?
General
