Telit Wireless Solutions LE910 - Serving Cell Information - #SERVINFO

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 223 of 509
Mod. 0808 2011-07 Rev.2
Serving Cell Information - #SERVINFO
#SERVINFO - Serving Cell Information
SELINT 2
AT#SERVINFO
Execution command reports information about serving cell, in the format:
(GSM network)
#SERVINFO: <B-ARFCN>,<dBM>,<NetNameAsc>,<NetCode>,
<BSIC>,<LAC>,<TA>,<GPRS>[,[<PB-ARFCN>],[<NOM>],
<RAC>,[<PAT>]]
(UMTS network)
#SERVINFO: <UARFCN>, <dBM>, <NetNameAsc>,<NetCode>,
<PSC>,<LAC>,<DRX>,<SD>,<RSCP>, <NOM>,<RAC>
(LTE network)
#SERVINFO:
<EARFCN>,<dBM>,[<NetNameAsc>],<NetCode>,<PhysicalCellId>,<TAC>,<DRX>,<
SD>,<RSRP>
where:
<B-ARFCN> - BCCH ARFCN of the serving cell
<dBM> - received signal strength in dBm
<NetNameAsc> - operator name, quoted string type
<NetCode> - string representing the network operator in numeric format: 5 or 6 digits
[country code (3) + network code (2 or 3)]
<BSIC> - Base Station Identification Code
<LAC> - Localization Area Code
<TA> - Time Advance: it’s available only if a GSM or GPRS is running
<GPRS> - GPRS supported in the cell
0 - not supported
1 - supported
The following information will be present only if GPRS is supported in the cell
<PB-ARFCN> -
• if PBCCH is supported by the cell
o if its content is the PBCCH ARFCN of the serving cell, then <PB-
ARFCN> is available
o else the label “hopping” will be printed
• else <PB-ARFCN> is not available
<NOM> - Network Operation Mode
..”I”
“II”
..”III”
<RAC> - Routing Area Colour Code
<PAT> - Priority Access Threshold
..0
..3..6