Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 222 of 509
Mod. 0808 2011-07 Rev.2
#MONIZIP – Compressed Cell Monitor
2. If the last setting done by #MONIZIP is 7, the execution command produces a
table-like formatted output, as follows:
(GSM network)
a. First row reports a complete set of GSM-related information for the
serving cell:
#MONIZIP: <bsic>,<lac>,<id>,<arfcn>,<dBm>,<C1value>, <C2val
ue>,<timadv>,<qual>,<cc><nc><CR><LF>
b. 2
nd
to 7
th
rows report a reduced set of GSM-related information for the
cells in the neighbours:
#MONIZIP: <bsic>,<lac>,<id>,<arfcn>,<dBm>,<C1value>, <C2valu
e>[<CR><LF>]
where:
<C1value> - C1 reselection parameter
<C2value> - C2 reselection parameter
other parameters as before
(UMTS network)
a. First row reports a set of information for the serving cell:
#MONI
ZIP: <net
name>,<psc
>,<rsc
p>,<l
ac>,<id>,<ec
io>,
<uarfcn
>,
<dBm>,<drx>,<scr>
b. the other rows report a set of information for all detected neighbour cells:
#MONIZ
IP: <psc>,<
rscp>,<
ecio>,<uar
fcn>,<scr>
See above for parameters description
Test command reports the maximum number of cells, in the neighbour list of the
serving cell excluding it, from which we can extract GSM-related information,
along with the ordinal number of the current selected cell, in the format:
#MONIZIP: (<MaxCellNo>,<CellSet>)
where:
<MaxCellNo> - maximum number of cells, in the neighbour list of the serving cell
and excluding it, from which we can extract GSM-related
information. This value is always 6.
<CellSet> - the last setting done with command #MONIZIP.
The refresh time of the measures is preset to 3 sec.
The timing advance value is meaningful only during calls or GPRS transfers active.
The serving cell is the current serving cell or the last available serving cell, if the
module loses coverage.
To Next Page
Loading...
Need help?
General
