Telit Wireless Solutions LE910 - E-Mail Authentication Password - #EPASSW; E-Mail Authentication User Name - #EUSER

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 413 of 509
Mod. 0808 2011-07 Rev.2
E-mail Authentication User Name - #EUSER
#EUSER - E-mail Authentication User Name
SELINT 2
AT#EUSER=
[<e-user>]
Set command sets the user identification string to be used during the authentication
step of the SMTP.
Parameter:
<e-user> - e-mail authentication User ID, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
Note: if no authentication is required then the <e-user> parameter shall be empty
"".
AT#EUSER?
Read command reports the current user identification string, in the format:
#EUSER: <e-user>
AT#EUSER=?
Test command returns the maximum allowed length of the string parameter <e-
user>.
Example
AT#EUSER="myE-Name"
OK
AT#EUSER?
#EUSER: "myE-Name"
OK
Note
It is a different user field than the one used for GPRS authentication (see
#USERID).
E-mail Authentication Password - #EPASSW
#EPASSW - E-mail Authentication Password
SELINT 2
AT#EPASSW=
[<e-pwd>]
Set command sets the password string to be used during the authentication step of
the SMTP.
Parameter:
<e-pwd> - e-mail authentication password, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
Note: if no authentication is required then the <e-pwd> parameter shall be empty
"".
AT#EPASSW=?
Test command returns the maximum allowed length of the string parameter <e-
pwd>.
Example
AT#EPASSW="myPassword"
OK
Note
It is a different password field than the one used for GPRS authentication (see
#PASSW).