Telit Wireless Solutions LE910 - Message Configuration; Message Format - +CMGF; Service Center Address - +CSCA

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 155 of 509
Mod. 0808 2011-07 Rev.2
+CPMS - Preferred Message Storage
SELINT 2
AT+CPMS="ME"
+CPMS: "ME",15,100,"ME",15,100,"ME",15,100
OK
(change memory to ME where there are 15 SMS positions occupied)
Reference
3GPP TS 27.005
Message Format - +CMGF
+CMGF - Message Format
SELINT 2
AT+CMGF=
[<mode>]
Set command selects the format of messages used with send, list, read and write
commands.
Parameter:
<mode>
0 - PDU mode, as defined in 3GPP TS 23.040 and 3GPP TS 23.041 (factory
default)
1 - text mode
AT+CMGF?
Read command reports the current value of the parameter <mode>.
AT+CMGF=?
Test command reports the supported value of <mode> parameter.
Reference
3GPP TS 27.005
4.1.5.2. Message Configuration
Service Center Address - +CSCA
+CSCA -Service Center Address
SELINT 2
AT+CSCA=
<number>
[,<type>]
Set command sets the Service Center Address to be used for mobile originated SMS
transmissions.
Parameter:
<number> - SC phone number in the format defined by <type>
<type> - the type of number
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
Note: to use the SM service, is mandatory to set a Service Center Address at which
service requests will be directed.