Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 123 of 509
Mod. 0808 2011-07 Rev.2
+CPUC - Price Per Unit And Currency Table
Test command returns the OK result code
Call meter maximum event - +CCWE
+CCWE – Call Meter maximum event
Set command is used to enable/disable sending of an unsolicited result
code +CCWV shortly before the ACM (Accumulated Call Meter)
maximum value is reached. The warning is issued approximately when 30
seconds call time remains. It is also issued when starting a call if less than
30 seconds call time remains.
Parameters:
<mode>:
0 Disable the call meter warning event (default)
1 Enable the call meter warning event
Note: the set command will respond with an error if the Accumulated Call
Meter service is not active in SIM
Read command reports the currently selected <mode> in the format:
+CCWE: <mode>
Test command reports the supported range of values for parameter
<mode>
Set voice mail number - +CSVM
+CSVM – Set Voice Mail Number
AT+CSVM=<mode>[,<number>[,<type
>]]
The number to the voice mail server is set with this command.
The parameters <number> and <type> can be left out if the
parameter <mode> is set to 0.
Parameters:
<mode>
0 – disable the voice mail number
1 – enable the voice mail number (factory default)
<number> - string type phone number of format specified by
<type>
<type> - type of address octet in integer format
129 - unknown type of number and ISDN/Telephony
To Next Page
Loading...
Need help?
General
