Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 33 of 509
Mod. 0808 2011-07 Rev.2
Select Active Service Class - +FCLASS
+FCLASS - Select Active Service Class
Set command sets the wireless module in specified connection mode (data, voice),
hence all the calls done afterwards will be data or voice.
Parameter:
<n>
0 - data
Read command returns the current configuration value of the parameter <n>.
Test command returns all supported values of the parameters <n>.
Default Reset Basic Profile Designation - &Y
&Y - Default Reset Basic Profile Designation
Execution command defines the basic profiles which will be loaded on startup.
Parameter:
<n>
0..1 - profile (default is 0): the wireless module is able to store 2 complete
configurations (see &W).
Note: differently from command Z<n>, which loads just once the desired profile,
the one chosen through command &Y will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as AT&Y0
Default Reset Full Profile Designation - &P
&P - Default Reset Full Profile Designation
Execution command defines which full profile will be loaded on startup.
Parameter:
<n>
0..1 – profile number: the wireless module is able to store 2 full configurations
(see command &W).
Note: differently from command Z<n>, which loads just once the desired profile,
the one chosen through command &P will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as AT&P0
To Next Page
Loading...
