Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 197 of 509
Mod. 0808 2011-07 Rev.2
Software Shut Down - #SHDN
#SHDN - Software Shutdown
Execution command causes device detach from the network and shut down.
Before definitive shut down an OK response is returned.
Note: after the issuing of this command any previous activity is terminated and the
device will not respond to any further command.
Note: to turn it on again Hardware pin ON/OFF must be tied low.
Test command returns the OK result code.
Extended Reset - #Z
Set command loads both base section and extended section of the specified user
profile stored with AT&W and selected with AT&P.
Parameter
<profile>
0 – user profile 0
1 – user profile 1
Test command tests for command existence.
Periodic Reset - #ENHRST
y>
Set command enables/disables the unit reset after <delay> minutes.
Parameters:
<mod>
0 – disables the unit reset (factory default)
1 – enables the unit reset only for one time
2 – enables the periodic unit reset
<delay> -
time interval after that the unit reboots; numeric value in minutes
Note: the settings are saved automatically in NVM only if old or new mod
is 2. Any change from 0 to 1 or from 1 to 0 is not stored in NVM
Note: the particular case AT#ENHRST=1,0 causes the immediate module
reboot. In this case if AT#ENHRST=1,0 follows an AT command that
stores some parameters in NVM, it is recommended to insert a delay of at
least 5 seconds before to issue AT#ENHRST=1,0, to permit the complete
NVM storing.
To Next Page
Loading...
Need help?
General
