Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 289 of 509
Mod. 0808 2011-07 Rev.2
#CSURVC - Network Survey (Numeric Format)
<croffset> - decimal Cell Reselection Offset, range 0 - 63
<penaltyt> - decimal Penalty Time, range 0 - 31
<t3212> - decimal T3212 Periodic Location Update Timer
<CRH> - decimal Cell Reselection Offset
(For non BCCH-Carrier)
<arfcn>,<rxLev>
where:
- decimal number; it is the RF channel
- decimal number; it is the receiption level (in dBm)
In 3G
<uarfcn>,<rxLev>,<mcc>,<mnc>,<scrcode>,<cellId>,<lac>,<cellStatus>,
<rscp>,<ecio>
<CR><LF><CR><LF><CR><LF>
where:
- the cell carrier frequency designated by UTRA Absolute Radio
Frequency Channel Number
- decimal number; it is the receiption level (in dBm)
- hexadecimal 3-digits number; it is the mobile country code
- hexadecimal 2-digits number; it is the mobile network code
- decimal number; it is the scrambling code
- cell identifier; if
last setting is 0,
is a decimal
number, else it is a 8-digits hexadecimal number
- location area code; if
last setting is 0,
is a decimal
number, else it is a 4-digits hexadecimal number
- string type; it is the cell status
0 - CELL_SUITABLE - the cell is a suitable cell.
1 - CELL_LOW_PRIORITY - the cell is low priority based on the received
system information.
2 - CELL_FORBIDDEN - the cell is forbidden.
3 - CELL_BARRED - the cell is barred based on the received system
information.
4 - CELL_LOW_LEVEL - the cell
is low.
5 - CELL_OTHER - none of the above e.g. exclusion timer running, no
BCCH available…etc.
<rscp> - decimal number; it is the RSCP level (in dBm)