Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 304 of 509
Mod. 0808 2011-07 Rev.2
Run AT command execution - #ATRUNDELAY
#ATRUNDELAY – Set the delay on Run AT command execution
<srv>,<delay>
Set command enables the use of a delay before the execution of AT command
received by Run AT service (TCP and SMS). It affects just AT commands
given through Run AT service.
<srv>
0 – TCP Run AT service
1 - SMS Run AT service
<delay> Value of the delay, in seconds. Range 0..30.
Default value 0 for both services (TCP and SMS).
Note1 - The use of the delay is recommended to execute some AT commands
that require network interaction or switch between GSM and GPRS services.
For more details see the RUN AT User Guide.
Note2: The delay is valid till a new AT#ATRUNDELAY is set.
Read command returns the current settings of parameters in the format:
#ATRUNDELAY: 0, <delayTCP>
#ATRUNDELAY: 1, <delaySMS>
OK
Test command returns the supported values for the ATRUNDELAY
parameters
To Next Page
Loading...
Need help?
General
