Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 239 of 509
Mod. 0808 2011-07 Rev.2
#NWEN – Network Emergency Number Update
Test command reports the range for the parameter <en>
Update PLMN List - #PLMNUPDATE
#PLMNUPDATE – Update PLMN List
AT#PLMNUPDATE=[<action
>,<MCC>,<MNC>[,<PLMNna
me>]]
Set command adds a new entry or updates an existing entry of the
module PLMN list.
Parameter:
- command action
0 - remove the entry with selected <MCC> and <MNC>. Parameter
<PLMNname> will be ignored
1 - update the entry with selected <MCC> and <MNC> if it is already
present, otherwise add it.
2 –
remove all entries. Parameters <MCC> and <MNC> are not used
in this case.
- Mobile Country Code. String value, length 3 digits.
- Mobile Network Code. String value, min length 2 digits,
max length 3 digits.
- Name of the PLMN; string value, max length 30
characters.
NOTE: the entries will be saved in NVM.
NOTE: this command supports up to 30 entries.
NOTE: entries added or updated with
are effective
only if #PLMNMODE is set to 2.
Read command returns the list of entries added or updated with set
command, in the format:
:
:
<MCC>,<MNC>,<PLMNname>
…
OK
NOTE: the entries are in increasing order by MCC and MNC
To Next Page
Loading...
Need help?
General
